I neglected to take many pictures of my brake line setup, but here are some stock pictures, and a couple of actual pictures of what I used, and where.

For the caliper, Earl's Performance 592032ERL Fittings:

[Linked Image]

For where the hard line comes down into the wheel well area, Earl's 989538ERL or 989545ERL fitting:

[Linked Image]

Used here:

[Linked Image]

and then used a -3an stainless line with a 90 degree bend on one end (caliper end). The ones I got were 21" long. You could probably get away with 18", as long as one end has the 90 degree bend.

[Linked Image]

[Linked Image]

This all eliminates the 3 piece brake line setup that is stock. I ran the stainless line through the bracket, wrapped some electrical tape on it to prevent vibration from wearing through it, and zip tied it tight.


Curt Shambeau
87 Mitsubishi Montero SWB (Turbo G64b wideblock conversion soon)