Front is already lifted as high as it will go, about 1.75". If I go any farther the CV boot will drag on the bottom arm.

I have been doing a lot of research here and in the service manual and I think the hubs just need to be taken apart, cleaned and reassembled. (I HOPE!!), Still think I'll look into getting some manual hubs, just gotta figure out where.


'87 GEN1 Dodge Raider 5-speed 2.6L w/ Weber (HAGAR)
'87 Ford Ranger STX 5-speed 2.9L V6
‘88 GEN1 Dodge Raider AT 2.6L w/ Weber (HELGA)
'95 Ford Bronco Eddy Bauer
'99 Toyota 4-Runner Limited 3" lift

WELCOME TO MY "USED" CAR LOT