so not much to add today .. but a bit ..

dropped the engine back in place , and started on the transmission .. and clutch .

blasted the fork to check for cracks and such .. , and then zinc'd

[Linked Image]

on this swap , you will need to use the 3.0L throwout bearing ..
[Linked Image]

greased the fork , and inner bearing surface , and installed .

[Linked Image]

installed the pilot bearing ..

[Linked Image]

[Linked Image]

the 3.4L clutch installed ..
with these kits you get a "goofy" plastic alignment tool .. but I like to use my own .. an original input shaft .

[Linked Image]


and finally the tranny back in place ..

[Linked Image]

also mounted the starter ..
on the bottom mount of the 3.0L belhousing .. it is threaded .. so is the starter .. you I had to drill the threads on the starter so the bolt would go threw

very simple
[Linked Image]


.


86 4x4 , fiberglass bed , 1/2 doors , hood, etc..
84 Custom 2WD 400HP supra suspension , full frame
83 Trekker SR5
NEW Trekker forum