re & re'd the ATM wire harness , for the MTM harness ..
also installed the front shaft .. had to remove the transfer flange because it has 10mm GRD11 studs , and stock 83 is 8mm .. so same as the rear shaft , I had to drill .

also mounted the front of the exhaust again , to get ready to build the rear ehaust pipes , and muffler ..

also fully mounted the fuel tank , and installed senders , and pump for good ..

I think thats it ..


86 4x4 , fiberglass bed , 1/2 doors , hood, etc..
84 Custom 2WD 400HP supra suspension , full frame
83 Trekker SR5
NEW Trekker forum