i have been unnsuccesful at selling my camaro during my time off with my injury. its a new year and i still want to sell it. i have put a lot of money and time in this car so far. my shoulder is healing but i still cant get under it to do the brake lines. so here is a list, ill add a few pics. someone buys the car from me on your recomendation and you will get $50 paypal or money order.
asking $3000 obo

inspection till 8/08

1980 chevy camaro
z28 fenders
z28 nose
z28 fender extentions
1 stock fender extention
twin turbo fiberglass hood
whaletail fiberglass trunk
aluminum body mounts
subframe connectors (not installed yet)
350 engine
rebuilt stock lower end with about 6-10k miles
58cc heads 1.90/1.64 valves
edelbrock performer rpm cam intake
edelbrock performer carb 700cfm rebuilt with electric choke installed.
1.5 roller rockers
headman headers
powermaster alt 100 amp (brand new just installed)
powermaster mini starter (brand new just installed with heat sheild and braided battery cable

2 brand new 3" catco cats
summit 2.5" x-pipe with 2 force mufflers and side exit.
griffin aluminum radiator
electric fan kit with ajustable thermostat.
sfi bellhousing
built muncie m-21 rockcrusher 4speed close ratio with hurst competition shifter
line locks
braided brake hoses (brand new )
stainless steel bake lines from master to wheel cyl (brand new )
crossdrilled rotors with bearings and hawk pads (brand new just installed)
wheel cylenders and shoes (brand new just installed)
3.08 posi rear
craiger sst rims (can use a polish)
futura tires (moderate wear)
racing bucket seats with 4 point harness
nordskog digital 6 gauge panel in blue with programable speedo (change tires, gears whatnot)

http://s6.photobucket.com/albums/y2...action=view&current=P1030071.flv

[Linked Image]
[Linked Image]


1995 nissan maxima se, 5spd short throw, aluminum flywheel and crank pully, stage 3 clutch, custom ported top end, full 2.5 exhaust jdm front end