Make certain you have access to all four spring slots - adjust the orientation if necessary:
[Linked Image]

Grease and install a pin in each pin bore with the pin step exposed:
[Linked Image]

Grease and install a spring over each pin step and push the spring into the recess as far as it will go:
[Linked Image]

Measure the gap down the center of the locker assembly - it must be between 0.145 and 0.176". Record the number and keep it. If you have a warranty claim, you'll be asked for this measurement. Feeler gauges might work better for this measurement, but mine appears to be near the center of the range at about 0.164":
[Linked Image]

Now set the case assembly aside while you tend to some not-so-fun chores..... more after dinner.

Frank


'89 [color:"white"]G-Raider[color:"white"] [color:"black"]Supercharged 3.0L, MegaSquirt 2, lockup A/T, 2.5" exhaust, 172k, Cibie H4s/Oscar SCs, Hella Micro DE fogs, Cobra CB, Superwinch hubs, LSD rear/Aussie Locker front, Bilsteins, Lifeline AGM, Rust-Oleum