Hi All, I have a broken temp sensor (2-wire), but cannot identify what it is. It is located on the passenger side of the thermostat housing, but is not identified in any of the FSM images. I have shaded it yellow in the attached image. I need to order a new part, but am not sure what to order just yet.
Is your switch depicted on this diagram? Alternative view from FSM.
1988 Mighty Max turbo 2.6 service body 1980 Power Wagon W400 Sundry Mitsubishi Montero Gen 1 parts, Gen 1 and Gen 2 Max parts Parts vehicles: 89 LS Montero 4-door, 2002 Sport AWD For Sale: 1989 Power Ram 50 extended cab, #277 Montero
Hi All, I spent some time reading through FSM & Parts Catalog from Mitsubishi links. I then looked up all of the P/N listed for the temperature sensors on pg 96 for the parts catalog, but none of them had plug ends that matched mine.
In the wiring harness page # 427/428 the p/n MB568959 is listed as a Water Temperature Switch for the AC Harness. When I look that part up on eBay the plug end matches, but it and the OEM Mitsubishi websites state that it is not a fit for my vehicle based on VIN?
Attached are the pages from parts catalog and matching image from eBay in next post
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2017 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.