Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Search E-Bay for your parts:
Search Amazon for your parts:

Search

Recent Posts on TrailTalk
1987, 2.6L, power steering pump bracket
by rxinhed. 05/17/19 12:50 AM
WTB 2 Door Montero
by rxinhed. 05/17/19 12:43 AM
91 Montero Gas Smell
by rxinhed. 05/14/19 12:32 AM
Skid plates for 87 Raider
by rxinhed. 05/14/19 12:30 AM
suzi the psychic
by Tuxedo_Ranch. 05/13/19 02:52 AM
87 Gen1 Rebuild in Kansas
by Tuxedo_Ranch. 05/12/19 12:43 PM
Introduction & New Raider
by Tuxedo_Ranch. 05/12/19 12:36 PM
Support 4x4Wire
New Topics on TrailTalk
WTB 2 Door Montero
by Malykaii. 05/16/19 04:35 PM
Skid plates for 87 Raider
by Tuxedo_Ranch. 05/11/19 03:00 AM
1987, 2.6L, power steering pump bracket
by Tincan. 05/11/19 02:01 AM
Need 1989 Windshield Washer Reservoir Tank
by polar. 05/07/19 06:23 PM
Need Complete Exhaust Assembly 89 V6 SWB
by polar. 05/07/19 06:05 PM
Gen 2 Alignment Issues - Caster
by red97rum. 05/07/19 12:34 AM
4x4 Gallery
Attila
99 Monterrible Sport
Scar the Cylon Raider
Mercenary Sergeant: Code Name "Sapphire"
Flex test after suspension mods
More News on the 'Wire

4x4Voice
4x4Wire
MUIRNet-News
OutdoorWire
Who's Online Now
1 registered members (Malykaii), 44 guests, and 6 spiders.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums37
Topics138,005
Posts1,080,082
Members14,915
Most Online581
Apr 3rd, 2017
Previous Thread
Next Thread
Print Thread
Rate Thread
I hit a snag on the engine build #1104707
11/25/18 08:06 PM
11/25/18 08:06 PM
DRTDEVL  Offline OP
J
Roll Me Over
Joined: Aug 2001
Posts: 2,941
Las Cruces, NM *****
Are there 2 different size heads on the G54B? I bolted the head down, lubed up the cam and dropped it in, then dropped the rocker shaft assembly on it... only to find the rear two bolt holes missing, and the back of the head is flat, rather than angled. The valve cover won't seal on the head, either (I dropped it down to look), since the cover arches to the rear, yet this head is flat.

I'll be checking with the guy I got the head from tomorrow, but it looks like I'm going to have to either salvage my current head (not sure if possible until I pull it from the old block) or just bite the bullet and spend another $400 for a complete reman head.


"A young man who does not have what it takes to perform military service is not likely to have what it takes to make a living." - John F. Kennedy

Proud owner of an 88 Montero (with a blown engine).
Support our sponsors
Re: I hit a snag on the engine build [Re: DRTDEVL] #1104708
11/25/18 08:43 PM
11/25/18 08:43 PM
DRTDEVL  Offline OP
J
Roll Me Over
Joined: Aug 2001
Posts: 2,941
Las Cruces, NM *****


"A young man who does not have what it takes to perform military service is not likely to have what it takes to make a living." - John F. Kennedy

Proud owner of an 88 Montero (with a blown engine).

Moderated by  Macka, Mudraider, off-roader, PajEvo, rxinhed 

OutdoorWire Websites

OutdoorWire

OutdoorWire

Portal page for OutdoorWire Access and Landuse Central Read More
4x4Voice

4x4Voice

California off road recreation news and information Read More
MUIRNet News

MUIRNet News

News and information about issues affecting outdoor recreation Read More
4x4Wire

4x4Wire

Off road recreation and 4x4 Technical news and information Read More
TrailTalk

TrailTalk

4x4Wire TrailTalk Forums for a variety of 4x4 tech information Read More

4x4Wire Tech Section

Jeep 4x4 Tech

Jeep 4x4 Tech

Jeep Tech from JeepWire - Mods, Maintenance, Tech and more... Read More
Isuzu 4x4 Tech

Isuzu 4x4 Tech

Isuzu Tech from 4x4Wire - Mods, Maintenance, Tech and more... Read More






4x4Wire Social:

| 4x4Wire on FaceBook | Google+4x4Wire on Google+|


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2017 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Page Time: 0.008s Queries: 15 (0.003s) Memory: 0.9769 MB (Peak: 1.0369 MB) Zlib disabled. Server Time: 2019-05-19 20:41:13 UTC