I recently purchased a 1990 Gen1 LWB 3.0 v6 Montero that is in a rather sad state. I am really excited about it. Have done a couple of mechanical fixes and have a couple of big projects (valve stem seals and lifter) ahead of me. Something I saw the past week (a lot of snow in CO) is that when i shift out of 4H the wheel lock light on the dash stays on, I need to mention that i do have auto hubs on the truck. If I switch the truck off for a minute and back on again the light is off. I also saw this morning that when I was backing up to park the light also went off. Any advice if this is normal. Do i need to give the hubs a good clean or is there a relay that might be stuck.
Really exited to use this forum and learn from you guys! I have been studying the valve stem seal replacement page!
Gen 1 1990 LWB Montero 3.0 v6 SOHC ineed of much love
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.