QuickLever Mirror Release
[an error occurred while processing this directive] Short Cuts

By: Terry L. Howe - 10/2003



DCP_0412.JPG
The mirror folded out of the way.
DCP_0413.JPG
The mirror adjusted for use.
DCP_0416.JPG
Drivers side.

Adjusting the mirrors on your Jeep and moving them out of the way is always been a compromise. If you leave your mirrors loose enough to move them out of the way, they get bumped out of adjustment all the time. If you tighten them up so they don't get bumped, you cannot move them out of the way. The QuickLever mirror release allows you to keep the mirrors tight and still move them out of the way with no tools.

QuickLever mirror releases work on 1955-1986 CJs external mirrors. This style mirror is also a nice upgrade for Wranglers if you want to take the doors off.

Installation of the QuickLever mirror release only takes a minute. Remove the bolt that holds on the mirror arm and put in the QuickLever. With the arm of the QuickLever concave out, tighten the nut down snug with your fingers. Flip the lever and it tightens down the mirror. After the QuickLever nut is properly set, you can just flip the lever to adjust the mirror or move it out of the way.

I just had to get a set of QuickLevers for my CJ-6. I'd had a set on my CJ-7 years ago and loved the convenience. The cost of convenience of QuickLever cannot be beat.


Contacts:

Related Information:

Trending on 4x4Wire TrailTalk Forums

New Topics on TrailTalk
Flying 1000mi to buy a 97 Montero SR sight unseen
by Macdrew77 - 09/19/20 04:18 AM
Raider 2.6 flywheel/starter question
by nonkjo - 09/17/20 02:28 PM
Introduction - B-Line Performance
by B_Line - 09/16/20 09:53 PM
Help me troubleshoot my Gen1 A/C problem
by 81for91 - 09/16/20 05:18 AM
GEN1 AT AW372 Manual Shaft Seal Replacement
by chadzeilenga - 08/31/20 04:34 AM
New guy getting a 91 Montero RS
by Trailmonkey - 08/30/20 03:18 AM
Recent Posts on TrailTalk
Introduction - B-Line Performance
by rxinhed - 09/19/20 09:11 PM
Help me troubleshoot my Gen1 A/C problem
by rxinhed - 09/19/20 09:06 PM
Raider 2.6 flywheel/starter question
by rxinhed - 09/19/20 09:01 PM
Flying 1000mi to buy a 97 Montero SR sight unseen
by Macdrew77 - 09/19/20 04:18 AM
Gen1 Montero SWB 4-cylinder front brake upgrade
by B_Line - 09/17/20 09:53 PM
1989 SWB Gen I Brake Line and Hose Source
by B_Line - 09/17/20 09:44 PM
87 Gen1 Rebuild in Kansas
by B_Line - 09/17/20 03:41 PM







4x4Wire Social:

| 4x4Wire on FaceBook


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.