staff_user

Suspension install on 3rd gen 4Runner (96-02)


Front install:

My front setup includes OME 881 heavy duty coil springs, Cornfed 2" aluminum spacers, and Bilstein heavy duty shocks.

First thing you should do is spray all the bolts with some PB blaster. This stuff works wonders on stuck and rusted bolts. Just spray it and let it sit for a few minutes. Makes life easier.

Then raise the vehicle up and support it on jack stands. Make sure to lift it high enough that you can droop the lower a-arm assembly down far enough that it doesn't hit the ground. Then remove the wheels.

Continue reading
Rate this blog entry:
0
14419 Hits
0 Comments

OutdoorWire Websites

OutdoorWire

OutdoorWire

Portal page for OutdoorWire Access and Landuse Central Read More
4x4Voice

4x4Voice

California OHV recreation news and information Read More
MUIRNet News

MUIRNet News

News and information about outdoor recreation Read More
4x4Wire

4x4Wire

Off road recreation and news and information Read More
TrailTalk 
Forums

TrailTalk Forums

4x4Wire TrailTalk Forums for 4x4 tech information Read More
  • 1

4x4Wire Tech Section

Jeep 4x4 Tech

Jeep 4x4 Tech

Jeep Tech from JeepWire Read More
Toyota 4x4 Tech

Toyota 4x4 Tech

Toyota Tech from 4x4Wire Read More
Mitsubishi 4x4 Tech

Mitsubishi 4x4 Tech

Mitsubishi Tech from 4x4Wire Read More
Isuzu 4x4 Tech

Isuzu 4x4 Tech

Isuzu Tech from 4x4Wire Read More
  • 1