4x4Wire

About you, your 4x4 and access

Reloading - My Observations

4x4Wire Reloading BenchTwo years ago I dismantled my reloading bench for a move from southern California to middle Tennessee.  My new location has limited space and I took my time rebuilding my reloading bench to be efficient and conserve space.  It is now complete and I recently tested my setup with a marathon reloading session.

With a supply of cases ready to load and winter weather with a mix of rain, snow, and cold, I opted to stay in warm surroundings as opposed to working on my Jeep in the unheated shop.

Powder, bullets and cases ready, I pulled my reloading dies out and set to work.  For this session, 9mm ammo was the intended end result.  I have two different sets of dies for 9mm, Hornady and RCBS. Each is a 3-die set.  The Hornady set was a new acquisition picked up at a swap meet for way less than a new die set would cost.

Continue reading
  1809 Hits
4x4Wire.com

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting. Copyright (c) 1999-2020 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission. You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material. All corporate trademarks are the property of their respective owners.